How to Replace a Sump Pump: A DIY Guide

Have you noticed a few problems in your basement? Are you concerned that your sump pump may be malfunctioning? Installing a sump pump is incredibly easy, but keeping it running properly is another story.

If you want to keep your basement dry, it’s a good idea to learn the basics of how to replace a sump pump.

When you’re ready to tackle this job, we’ve got the steps you need to do the job successfully.

Gather Your Materials

You will need a few materials before you start installing your new sump pump. Get a new one, a discharge pipe, a check valve, PVC primer, and cement.

Ready the drill, screwdriver, level, tape measure, and the wrench. You may also need a new pit liner if your old one is damaged.

Once you have all of your materials, you can begin the installation process.

Prepare the Area for Pump Replacement

If your sump pump is foundation mounted, such as a sump pump in crawl space, there are a few things you should know before you start your replacement project. Make sure the new sump pump is the same size and model as your old one.

It’s important to level the new sump pump before installing it. This will help prevent any damage to your foundation or property.

In order to install a new sump pump, you will need to remove the old one. This can be done by disconnecting the power source and the discharge pipe. Remove the check valve and any fittings that are attached to the discharge pipe.

Once the old sump pump is removed, clean the area around the new sump pump. This includes removing any debris or stones that could block the drainage hole.

Install the New Sump Pump

Insert the new sump pump into the pit and connect the discharge pipe to the new pump. Finally, connect the electrical wire to the new pump. The sump pump usually comes with a sump pump installation guide, so it will be easy for you to execute.

If you are installing a new sump pump, be sure to heed all warnings. Some models are designed for specific types of soil and conditions, so be sure to check the manufacturer’s specifications before purchasing. Installation typically requires a few hours, so be sure to allow plenty of time.

Test Your New Sump Pump

Make sure the power is off to the pump. Fill the pit with water, either with a hose or by bailing out any existing water. Once the pit is full, turn on the power to the pump and let it run until the pit is emptied.

If the pump does not seem to be working properly, check the float switch to make sure it is not stuck. You may also need to check the outlet pipe to make sure it is not blocked.

Knowing How to Replace a Sump Pump

With this article, you have learned how to replace a sump pump.

Replacing one is a relatively easy do-it-yourself project that you can complete in a few hours. This guide provides easy-to-follow instructions on how to remove your old sump pump and install a new one.

Keep scrolling to find more do-it-yourself home improvement tips on this page!

Previous Post
Next Post

Leave a Reply

Your email address will not be published. Required fields are marked *